Hazard communication training: what OSHA requires and when

Last reviewed November 18, 2026  ·  4 sources

Short answer

OSHA requires hazard communication training for every employee who can be exposed to hazardous chemicals, at their initial assignment and whenever a new chemical hazard they have not been trained about comes into their work area (29 CFR 1910.1200(h)(1)). There is no yearly interval in the rule. Training must cover how to detect a chemical release, the hazards, how to protect yourself, and your own program: labels, pictograms and how to read the 16-section safety data sheet (SDS).

Under the 2024 update, employers add training for newly identified hazards by November 20, 2026 (substances) and May 19, 2028 (mixtures). The standard requires no written training record, but the free one-page record below is the simplest proof.

Hazcom training requirements

Paragraph (h) of the hazard communication standard splits the requirement into information and training. Both are required.

PartRuleWhat staff must get
Information1910.1200(h)(2)(i)The requirements of the standard
Information1910.1200(h)(2)(ii)The operations in their work area where hazardous chemicals are present
Information1910.1200(h)(2)(iii)Where the written program, the chemical list and the SDS are kept
Training1910.1200(h)(3)(i)How to detect the presence or release of a hazardous chemical (odor, appearance, monitoring)
Training1910.1200(h)(3)(ii)The physical and health hazards of the chemicals in the work area, including simple asphyxiation, combustible dust, pyrophoric gas and hazards not otherwise classified
Training1910.1200(h)(3)(iii)How to protect themselves: work practices, emergency procedures and PPE
Training1910.1200(h)(3)(iv)The details of your program: shipped container labels, your workplace labeling system, and the SDS, "including the order of information and how employees can obtain and use the appropriate hazard information"

The rule asks for "effective information and training." Training "may be designed to cover categories of hazards (e.g., flammability, carcinogenicity) or specific chemicals," as long as chemical-specific information is always available on labels and SDS. The standard applies to every employer with exposed employees; it has no small-office exemption.

What goes into the program itself (the chemical list, labeling rules, non-routine tasks) is on the written hazard communication program template. This page covers the training.

How often is hazard communication training required?

  1. At the time of initial assignment, for each new employee who can be exposed.
  2. When a new chemical hazard is introduced into their work area that they have not been trained about. The trigger is a new hazard, not a new product: if training covered a category of hazard (for example flammability) and the new product's hazards fall in it, the rule's wording does not call for new training. A product with a hazard staff have not been trained on does.
  3. For the 2024 update, by the dates below, if your updated labels or SDS show newly identified hazards.

OSHA sets no yearly hazcom refresher. Repeating it every year with your other OSHA training is office practice, and an easy way to catch new products and new staff. For a dental office, the other yearly topics are in OSHA training for dental offices.

GHS training: labels and pictograms

OSHA's standard follows the United Nations Globally Harmonized System of Classification and Labelling of Chemicals (GHS), "primarily Revision 7." GHS training means teaching staff to read the label and the SDS.

A supplier label shows (1910.1200(f)(1)): the product identifier, signal word ("Danger" or "Warning"), hazard statements, pictograms, precautionary statements, and the name, U.S. address and U.S. phone number of the manufacturer, importer or other responsible party.

Pictograms are a black symbol on a white background in a red diamond. Each pictogram appears only once on a label. OSHA's quick card lists them:

PictogramHazards
Health hazardCarcinogen, mutagenicity, reproductive toxicity, respiratory sensitizer, target organ toxicity, aspiration toxicity
FlameFlammables, pyrophorics, self-heating, emits flammable gas, self-reactives, organic peroxides, desensitized explosives
Exclamation markIrritant (skin and eye), skin sensitizer, acute toxicity (harmful), narcotic effects, respiratory tract irritant
Gas cylinderGases under pressure, chemicals under pressure
CorrosionSkin corrosion and burns, eye damage, corrosive to metals
Exploding bombExplosives, self-reactives, organic peroxides
Flame over circleOxidizers
Skull and crossbonesAcute toxicity (fatal or toxic)
Environment (not required by OSHA)Aquatic toxicity

Containers you fill yourself, such as spray bottles of disinfectant, carry either the full supplier label information or the product identifier plus words, pictures or symbols that give general information about the hazards (1910.1200(f)(6)). Labels must be in English; you may add another language, such as Spanish, as long as the English is there too (1910.1200(f)(10)).

SDS training: the 16 sections

Every SDS is in English and has these 16 numbered sections in this order (1910.1200(g)(2)):

  1. Identification
  2. Hazard(s) identification
  3. Composition/information on ingredients
  4. First-aid measures
  5. Fire-fighting measures
  6. Accidental release measures
  7. Handling and storage
  8. Exposure controls/personal protection
  9. Physical and chemical properties
  10. Stability and reactivity
  11. Toxicological information
  12. Ecological information
  13. Disposal considerations
  14. Transport information
  15. Regulatory information
  16. Other information, including date of preparation or last revision

OSHA does not enforce the content of sections 12 to 15, because those topics are outside its jurisdiction, but they are still part of the format. For staff, the sections they use most are 2 (hazards), 4 (first aid), 6 (spills), 7 (handling and storage) and 8 (PPE). A good SDS exercise: hand each person a product from their work area and have them find its SDS and answer "what PPE?" and "what if it splashes in my eye?"

Does OSHA require a hazcom training record?

No. Paragraph (h) requires the training but has no record-keeping requirement. OSHA's 1989 letter of interpretation explains how compliance is checked instead: "compliance officers conduct interviews with affected employees and responsible management officials" and review the written program, and a trend of answers showing training is not happening can lead to a citation.

In practice, keep a record anyway. A dated sheet with the topics, the products covered, the trainer and each employee's signature shows who was trained, on what and when. Keep it with your written program. The record below is built from paragraph (h).

The 2024 update: November 20, 2026 and May 19, 2028

OSHA amended the standard effective July 19, 2024. Manufacturers, importers and distributors update their classifications, labels and SDS first. For employers, 1910.1200(j) as it reads in the eCFR today says all employers shall, as necessary, update any alternative workplace labeling, update the hazard communication program, and "provide any additional employee training" for newly identified hazards:

  • for substances, no later than November 20, 2026, and
  • for mixtures, no later than May 19, 2028.

Between May 20, 2024 and those dates, employers may comply with either the current standard or the version revised as of July 1, 2023, or both (1910.1200(j)(4)). In practice: when an updated SDS or label arrives, compare section 2 with the old one. If a hazard is new, update your in-office labels and chemical list and train the staff who use the product. Many products in a healthcare office, such as disinfectants and bonding agents, are mixtures.

California (Cal/OSHA 8 CCR 5194)

California's Hazard Communication standard, 8 CCR 5194(h), sets the same timing (initial assignment and whenever a new chemical hazard is introduced) and the same topics, plus:

  • employees are told of their right to receive information on the hazardous chemicals they may be exposed to, of their physician's or collective bargaining agent's right to receive it, and of their right against discharge or discrimination for using these rights (5194(h)(2)(G)), and
  • when a new or revised SDS shows significantly increased risks, or new measures needed to protect employees, that information goes to employees "on a timely basis not to exceed 30 days after receipt" (5194(h)(3)).

The 5194 text on Cal/OSHA's site, checked November 18, 2026, still shows its earlier effective dates, not the federal 2026 and 2028 dates. Check with Cal/OSHA whether it has adopted the 2024 changes. Other OSHA State Plans have their own standards and can differ in details and dates.

How to run hazard communication training

  1. Print your chemical list and open the SDS binder or SDS app. Training follows what your office actually uses.
  2. Cover the three information items: the standard, where chemicals are used in each person's work area, and where the program, list and SDS are kept.
  3. Teach the label: signal word, hazard statements and the pictograms, with real containers from the supply cabinet.
  4. Teach the SDS: the 16 sections and the ones staff use most. Have each person find one SDS on their own.
  5. Go through protection and emergencies: gloves and eyewear for each product, spill steps and the eyewash location. Where corrosive chemicals are used, see eyewash station requirements.
  6. Record the session on the training record below. Repeat for each new hire and each new chemical hazard.

In a dental office, include x-ray developer and fixer if you still use film; the rest of x-ray safety is in dental radiation safety.

Free hazard communication training record

One page: session details, the paragraph (h) topics as a checklist, the products covered and 8 signature lines. Use one sheet per session.

Hazard communication training record

complyday.com
Office:Date:Trainer (name and title):Length (minutes):

Reason for this session (check one)

  • Initial assignment (new employee)(h)(1)
  • New chemical hazard in the work area(h)(1)
  • Newly identified hazard on an updated label or SDS (2024 update)(j)
  • Yearly refresherOffice practice

Topics covered

  • The requirements of the hazard communication standard(h)(2)(i)
  • Operations in the work area where hazardous chemicals are present(h)(2)(ii)
  • Where the written program, chemical list and SDS are kept(h)(2)(iii)
  • How to detect the presence or release of a hazardous chemical(h)(3)(i)
  • Physical and health hazards of the chemicals in the work area(h)(3)(ii)
  • Protection: work practices, emergency procedures, PPE(h)(3)(iii)
  • Labels, pictograms, the office labeling system, and how to find and read an SDS(h)(3)(iv)
Products or hazard categories covered:
Employee (name)Job titleSignature

OSHA 29 CFR 1910.1200(h) requires the training but no written record; keep this sheet with your written hazard communication program as proof. California (8 CCR 5194(h)) adds: tell employees their rights under the Hazardous Substances Information and Training Act, and give them significantly increased risks from a new or revised SDS within 30 days of receipt.

Open the printable hazard communication training record or use the download button.

The free way is this record, your written program and your SDS binder. ComplyDay is the faster way: hazard communication is one of six yearly courses (seven in California) on staff phones, in English or Spanish, with a trainer to message during the course and a certificate when the quiz is passed. It also writes your hazard communication program and builds the chemical list from photos of product labels with SDS links.

Questions

How often is hazard communication training required?

OSHA requires it at each employee’s initial assignment and whenever a new chemical hazard they have not been trained about is introduced into their work area (29 CFR 1910.1200(h)(1)). The standard sets no yearly interval. Yearly refreshers are office practice. Under the 2024 update, employers also give any additional training needed for newly identified hazards by November 20, 2026 for substances and May 19, 2028 for mixtures.

Does OSHA require a written record of hazcom training?

The hazard communication standard has no training record requirement. OSHA checks training by interviewing employees and reviewing the written program, as its 1989 letter of interpretation describes. Keep a dated sign-in sheet or certificate anyway: it is the simplest way to show who was trained, on what and when.

What is GHS training?

GHS is the United Nations Globally Harmonized System of Classification and Labelling of Chemicals. OSHA’s hazard communication standard follows it (“primarily Revision 7”), so GHS training usually means training on the label elements, the pictograms and the 16-section safety data sheet. It is part of hazard communication training, not a separate OSHA requirement.

What should SDS training cover?

The standard requires training on the safety data sheet, “including the order of information and how employees can obtain and use the appropriate hazard information” (1910.1200(h)(3)(iv)). In practice: where the SDS are kept, how to find the one for a product, and which sections answer which questions, such as section 2 for hazards, section 4 for first aid and section 8 for protective equipment.

Can hazard communication training be online?

The standard does not set a format. It requires “effective information and training” and training on your own program, labeling system and SDS access, which a general course cannot know. Online training plus a short walk-through of your own binder, labels and eyewash covers both.

Is hazard communication training different in California?

California’s standard, 8 CCR 5194, sets the same timing and topics and adds two items: employees must be told of their rights under the Hazardous Substances Information and Training Act, and when a new or revised SDS shows significantly increased risks, that information goes to employees within 30 days of receipt.

Sources

  1. eCFR: 29 CFR 1910.1200, Hazard communication
  2. OSHA: Hazard Communication Standard pictogram quick card (OSHA 3491)
  3. OSHA: Letter of interpretation on hazard communication training compliance (July 24, 1989)
  4. Cal/OSHA: 8 CCR 5194, Hazard Communication